Installation

To use the QWS3270 Automation component both the component dll (QWS3270 Automation.dll) and it's proxy/stub (QWS3270 Automationps.dll) must be registered in your Windows registry. The registration process happens automatically during the install of QWS3270.

If for any reason you need to re-install the QWS3270 Automation components, register the QWS3270 Automation COM dll and its proxy/stub as follows:

1. locate the files QWS3270 Automation.dll and QWS3270 Automationps.dll (by default they are installed in the application's main directory).

2. Open a command prompt and navigate to the directory containing the two dlls (typically the QWS3270 installation directory).

3. Type the following at the command prompt:

regsvr32 "QWS3270 Automation.dll" <ENTER>

regsvr32 "QWS3270 Automationps.dll" <ENTER>

You should see two message boxes each confirming the registration of one of the files in the Windows registry.

To un-register the files:

1. locate the files QWS3270 Automation.dll and QWS3270 Automationps.dll (by default they are installed in the application's main directory).

2. Open a command prompt and navigate to the directory containing the two dlls (typically the QWS3270 installation directory).

3. Type the following at the command prompt:

regsvr32 /u "QWS3270 Automation.dll" <ENTER>

regsvr32 /u "QWS3270 Automationps.dll" <ENTER>

This will remove the registry entries, and you will no longer be able to use the automation components.